Eco Air ECO1202SQN Installation Manual download pdf (Page 8)

INSTALLATION INSTRUCTIONS

1. Pass the female half coupling through the hole in the wall.

2. Position the upper claw (at the back of the indoor unit) on the upper hook of the

installation plate, gently rock the indoor unit from side to side to check that it is securely

hooked.

3. Temporarily place a cushioning material between the indoor unit and the wall as illustrated

below to make it easier to completely route the flexi hose through the wall. Remove the

cushioning material.

4. Gently push the lower part of the indoor unit up against the wall, then gently rock the indoor

unit from side to side, up and down to check that it is securely hooked.

Upper hook

Lower hook

Cushioning

material

Fig.8

4. Indoor unit installation

3. Drainage Installation

1. Run the drain hose sloping downward to ensure condensation water is being drained externally,

any rise in the drain hose will prevent condensation water to flow externally on gravity as

illustrated below (Fig. 7).

2. When connecting extension drain hose, insulate the connecting part of extension

drain hose with a shield pipe, avoiding any slack on the drain hose.

Do not form a rise

Do not put the hose

end into water

Fig.7

5. Piping and wrapping

Bundle the tubing, connecting cable with

tape securely and evenly as shown in Fig.9.

Because the condensed water from the

indoor unit is gathered in condensation

tray and should be piped out externally.

Indoor unit

Connective

pipe

Pipe room

Condensation tray

Wrapping belt

Connective

cable

Drain hose

Fig.9

Note: Route the flexi hose with female half coupling through the hole in the wall

from the rear of the indoor unit (right) or (left).

Condensation Water

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Eco Air ECO1202SQN Installation Manual Page 8

Comments to this Manuals

Related products and manuals for Split-system air conditioners Eco Air ECO1202SQN